Home > BRONZE > Bronze - Wrought Alloys > C67300
We found 0 results matching your criteria.

Atlas carries C67300 Leaded Silicon Manganese Brass Solid Bar Stock in diameters ranging from 3/4" to 8". We carry full bars and we will cut the material to length. Some of the typical areas that C67300 is used in, is as follows: Hydraulic piston shoes, cylinder liners, and cams

__________________________________________________________________________________________






Diameter (inch)Part Number
.75000"6730S-6
.87500"6730S-7
.93750"6730S-7.5
1.0000"6730S-8
1.0313"6730S-8.25
1.0938"6730S-8.75
1.1250"6730S-9
1.1875"6730S-9.5
1.2500"6730S-10
1.3125"6730S-10.5
1.5000"6730S-12
1.5625"6730S-12.5
1.6250"6730S-13
1.6875"6730S-13.5
1.7500"6730S-14
1.8750"6730S-15
2.0000"6730S-16
2.1250"6730S-17
2.2500"6730S-18
2.5000"6730S-20
2.7500"6730S-22
3.0000"6730S-24
3.2500"6730S-26
3.5000"6730S-28
4.0000"6730S-32
5.5000"6730S-44
6.0000"6730S-48
6.5000"6730S-52
7.5000"6730S-60
8.0000"6730S-64

_________________________________________________________________________________________



TYPICAL USES:
Some of the typical areas that C67300 is used in, is as follows: Hydraulic piston shoes, cylinder liners, and cams



CHEMICAL COMPOSITION:

(%max., unless shown as range or min.)
Cu(1)AlFePbMnNi(2)SiSnZn
Min./Max.58.0-63.0.25.50.40-3.02.0-3.5.25.50-1.5.30Rem.
Nominal60.5--1.72.7-1.0-34.1

(1) Cu value includes Ag.
(2) Ni value includes Co.
Note: Cu + Sum of Named Elements, 99.5% min.


MECHANICAL PROPERTIES
:

(measured at room temperature, 68 F (20 C)
Temper Section
Size
Cold
Work
Typ/
Min
Temp Tensile
Strength
Yield
Strength
(0.5% ext.
under load)
Yield
Strength
(0.2%
offset)
Yield
Strength
(0.05%
offset)
El Rockwell
Hardness
Vickens
Hard.
Brinell
Hard.
Shear
Strength
Fatigue
Strength*
Izod
Impact
Strength

in. %
F ksi ksi ksi ksi % B C F 30T 500 500 3000 ksi ksi ft-lb

mm.

C MPa MPa MPa MPa







MPa MPa J
Bar
H50<1.000min686540--1180--------0.0

<25.4

20448276--1180--------0.0

*Fatigue Strength: 100 x 10 6cycles,
unless indicated as [N]X 106.


APPLICABLE SPECIFICATIONS:

ProductSpecification
BarSAE J461, J463
ForgingsSAE J461, J463
RodSAE J463, J461
ShapesSAE J463, J461