Atlas carries C65500 High Silicon Bronze in
Solid Bar & Plate stock. We carry a very large range of sizes and will cut the
material to length.
__________________________________________________________________________________________
Click on the below image to select your size:
 
__________________________________________________________________________________________
TYPICAL USES:
Some of the typical areas that C65500 is used in, is as follows: Hydraulic
pressure lines, bolts, burrs, butts, clamps, cotter pins, hinges,
marine hardware, nails, nuts, pole line hardware, screws, propeller
shafts.
CHEMICAL COMPOSITION:
(%max., unless shown as range or min.)
| |
Cu(1) | Fe | Pb | Mn | Ni(2) | Si | Zn |
|---|
| Min./Max. | Rem. | .8 | .05 | .50-1.3 | .6 | 2.8-3.8 | 1.5 | | Nominal | 97.0 | - | - | .9 | - | 3.0 | - |
(1) Cu value includes Ag.
(2) Ni value includes Co.
Note: Cu + Sum of Named Elements, 99.5% min.
MECHANICAL PROPERTIES:
(measured at room temperature, 68 F (20 C)
| Temper |
Section
Size |
Cold
Work |
Typ/
Min |
Temp |
Tensile
Strength |
Yield
Strength
(0.5% ext.
under load) |
Yield
Strength
(0.2%
offset) |
Yield
Strength
(0.05%
offset) |
El |
Rockwell
Hardness |
Vickens
Hard. |
Brinell
Hard. |
Shear
Strength |
Fatigue
Strength* |
Izod
Impact
Strength |
|---|
| in. |
% |
| F |
ksi |
ksi |
ksi |
ksi |
% |
B |
C |
F |
30T |
500 |
500 |
3000 |
ksi |
ksi |
ft-lb |
| mm. |
|
| C |
MPa |
MPa |
MPa |
MPa |
|
|
|
|
|
|
|
|
MPa |
MPa |
J |
| Flat Products | | OS015 | 0.04 | 0 | TYP | 68 | 63 | 30 | - | - | 55 | 66 | - | 90 | - | - | - | - | 45 | - | 0.0 |
| 1 |
|
| 20 | 434 | 207 | - | - | 55 | 66 | - | 90 | - | - | - | - | 310 | - | 0.0 | | H02 | 0.04 | 0 | TYP | 68 | 78 | 45 | - | - | 17 | 87 | - | - | 75 | - | - | - | 50 | - | 0.0 |
| 1 |
|
| 20 | 538 | 310 | - | - | 17 | 87 | - | - | 75 | - | - | - | 345 | - | 0.0 | | Rod | | H06 | 1 | 50 | TYP | 68 | 108 | 60 | - | - | 13 | 95 | - | - | - | - | - | - | 62 | - | 0.0 |
| 25.4 |
|
| 20 | 745 | 414 | - | - | 13 | 95 | - | - | - | - | - | - | 427 | - | 0.0 | | Wire | | H01 | 0.08 | 0 | TYP | 68 | 80 | 48 | - | - | 20 | - | - | - | - | - | - | - | 52 | - | 0.0 |
| 2 |
|
| 20 | 552 | 331 | - | - | 20 | - | - | - | - | - | - | - | 359 | - | 0.0 | | H00 | 0.08 | 0 | TYP | 68 | 70 | 40 | - | - | 35 | - | - | - | - | - | - | - | 48 | - | 0.0 |
| 2 |
|
| 20 | 483 | 276 | - | - | 35 | - | - | - | - | - | - | - | 331 | - | 0.0 | | Flat Products | | OS035 | 0.04 | 0 | TYP | 68 | 60 | 25 | - | - | 60 | 62 | - | 85 | - | - | - | - | 43 | - | 0.0 |
| 1 |
|
| 20 | 414 | 172 | - | - | 60 | 62 | - | 85 | - | - | - | - | 296 | - | 0.0 | | H06 | 0.04 | 0 | TYP | 68 | 104 | 60 | - | - | 6 | 96 | - | - | 80 | - | - | - | 60 | - | 0.0 |
| 1 |
|
| 20 | 717 | 414 | - | - | 6 | 96 | - | - | 80 | - | - | - | 414 | - | 0.0 | | Tube | | H80 | 0.065 | 35 | TYP | 68 | 93 | - | - | - | 22 | 92 | - | - | 78 | - | - | - | - | - | 0.0 |
| 1.7 |
|
| 20 | 641 | - | - | - | 22 | 92 | - | - | 78 | - | - | - | - | - | 0.0 | | Flat Products | | H04 | 0.04 | 0 | TYP | 68 | 94 | 58 | - | - | 8 | 93 | - | - | 78 | - | - | - | 57 | - | 0.0 |
| 1 |
|
| 20 | 648 | 400 | - | - | 8 | 93 | - | - | 78 | - | - | - | 393 | - | 0.0 | | H08 | 0.04 | 0 | TYP | 68 | 110 | 62 | - | - | 4 | 97 | - | - | 81 | - | - | - | 63 | - | 0.0 |
| 1 |
|
| 20 | 758 | 427 | - | - | 4 | 97 | - | - | 81 | - | - | - | 434 | - | 0.0 | | Rod | | OS050 | 1 | 0 | TYP | 68 | 58 | 22 | - | - | 60 | 60 | - | - | - | - | - | - | 43 | - | 0.0 |
| 25.4 |
|
| 20 | 400 | 152 | - | - | 60 | 60 | - | - | - | - | - | - | 296 | - | 0.0 | | H04 | 1 | 36 | TYP | 68 | 92 | 55 | - | - | 22 | 90 | - | - | - | - | - | - | 58 | - | 0.0 |
| 25.4 |
|
| 20 | 634 | 379 | - | - | 22 | 90 | - | - | - | - | - | - | 400 | - | 0.0 | | Wire | | H08 | 0.08 | 0 | TYP | 68 | 145 | 70 | - | - | 3 | - | - | - | - | - | - | - | 70 | 30 | 0.0 |
| 2 |
|
| 20 | 1000 | 483 | - | - | 3 | - | - | - | - | - | - | - | 483 | 207 | 0.0 | | Flat Products | | OS070 | 0.04 | 0 | TYP | 68 | 56 | 21 | - | - | 63 | 40 | - | 76 | - | - | - | - | 42 | - | 0.0 |
| 1 |
|
| 20 | 386 | 145 | - | - | 63 | 40 | - | 76 | - | - | - | - | 290 | - | 0.0 | | Rod | | H02 | 1 | 20 | TYP | 68 | 78 | 45 | - | - | 35 | 85 | - | - | - | - | - | - | 52 | - | 0.0 |
| 25.4 |
|
| 20 | 538 | 310 | - | - | 35 | 85 | - | - | - | - | - | - | 359 | - | 0.0 | | Wire | | OS035 | 0.08 | 0 | TYP | 68 | 60 | 25 | - | - | 60 | - | - | - | - | - | - | - | 43 | - | 0.0 |
| 2 |
|
| 20 | 414 | 172 | - | - | 60 | - | - | - | - | - | - | - | 296 | - | 0.0 | | H04 | 0.08 | 0 | TYP | 68 | 125 | 65 | - | - | 5 | - | - | - | - | - | - | - | 65 | 29 | 0.0 |
| 2 |
|
| 20 | 862 | 448 | - | - | 5 | - | - | - | - | - | - | - | 448 | 200 | 0.0 | | Tube | | OS050 | 0.065 | 0 | TYP | 68 | 57 | - | - | - | 70 | 45 | - | - | - | - | - | - | - | - | 0.0 |
| 1.7 |
|
| 20 | 393 | - | - | - | 70 | 45 | - | - | - | - | - | - | - | - | 0.0 | | Wire | | H02 | 0.08 | 0 | TYP | 68 | 98 | 57 | - | - | 8 | - | - | - | - | - | - | - | 58 | - | 0.0 |
| 2 |
|
| 20 | 676 | 393 | - | - | 8 | - | - | - | - | - | - | - | 400 | - | 0.0 | | Flat Products | | H01 | 0.04 | 0 | TYP | 68 | 68 | 35 | - | - | 30 | 75 | - | - | 67 | - | - | - | 47 | - | 0.0 |
| 1 |
|
| 20 | 469 | 241 | - | - | 30 | 75 | - | - | 67 | - | - | - | 324 | - | 0.0 |
*Fatigue Strength: 100 x 10 6cycles,
unless indicated as [N]X 106.
APPLICABLE SPECIFICATIONS:
| Product | Specification |
| Bar | SAE J463, J461 | | Bar, Forging | ASTM B124 | | Bar, Rolled | ASME SB98
ASTM B98, B96
SAE J463, J461 | | Bar, Rolled, Pressure Vessels | ASME SB96
ASTM B96 | | Bolts | ASTM F468 | | Forgings, Die | ASTM B283 | | Nuts | ASTM F467 | | Pipe | ASME SB315
ASTM B315 | | Plate | ASME SB96
ASTM B96 | | Plate, Bridge and Bearing | ASTM B100 | | Plate, Clad | ASTM B432 | | Plate, Pressure Vessels | ASME SB96
ASTM B96 | | Rod | ASME SB98
ASTM B98
SAE J463, J461 | | Rod, Forging | ASTM B124 | | Screws | ASTM F468 | | Shapes | ASME SB98
ASTM B98
SAE J463, J461 | | Shapes, Forging | ASTM B124 | | Sheet | ASME SB96
ASTM B96
SAE J461, J463 | | Sheet, Bridge and Bearing | ASTM B100 | | Sheet, Pressure Vessels | ASME SB96
ASTM B96 | | Strip | ASME SB96
ASTM B96
SAE J463, J461 | | Studs | ASTM F468 | | Tube | ASME SB315
ASTM B315
MILITARY MIL-T-8231 | | Wire | ASTM B99, B105 |
|
