Home > PRODUCTS > Iron Alloys > 65-45-12 Ductile Iron
We found 0 results matching your criteria.

Atlas carries
65-45-12 Ductile Iron Solid Bar & 65-45-12 Ductile Iron Plate that contains nodular graphite in a matrix of ferrite with small amounts of pearlite. The ferritic structure gives excellent machinability with good surface finishes along with optimal impact strengths, fatigue properties, electrical conductivity and high magnetic permeability. This iron has approximately the same tensile and yield strengths as AISI 1020 steel in the as-rolled condition. This specification conforms to ASTM A536 grade 65-45-12.

__________________________________________________________________________________________






__________________________________________________________________________________________



HEAT TREAT RESPONSE:

65-45-12 can be oil quench hardened from 1600° F (885° C) to Rockwell C 50 minimum on the outside of the bar. Hardness in the core will be less than the hardness on the outside surfaces. Typical jominy end quench test data are shown in the section on Heat Treating.

This grade also responds well to surface hardening methods such as flame or induction heat treating. It is well suited for austempering because of the low residual alloy content, and the highly ferritic matrix provides predictable growth with minimal heat-distortion.




CHEMICAL COMPOSITION:



*Carbon and silicon targets are specified for each bar size in order to maintain mechanical properties. Magnesium is added as an inoculant to produce nodular graphite.



MICROSTRUCTURE:


The microstructure consists of Types I & II nodular graphite as defined in ASTM A247. The matrix is ferrite with approximately 5-25% pearlite. The "rim" will have a higher nodular count and will be mostly ferrite. Chill carbides will be less than 5% in any field at 100x and will be well dispersed.




SPECIFICATIONS:




Atlas carries
65-45-12 Ductile Iron Solid Bar & 65-45-12 Ductile Iron Plate that contains nodular graphite in a matrix of ferrite with small amounts of pearlite. The ferritic structure gives excellent machinability with good surface finishes along with optimal impact strengths, fatigue properties, electrical conductivity and high magnetic permeability. This iron has approximately the same tensile and yield strengths as AISI 1020 steel in the as-rolled condition. This specification conforms to ASTM A536 grade 65-45-12.